BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 213 / 356

213
Evinrude ICON Remote Control System
ICON System Settings
10
IMPORTANT:
The Engine Identity Plug over-
rides any previous EMM instance setting.
Calibrate Actuator Stroke
The Evinrude ICON actuators do NOT require
periodic calibration. The shift and/or throttle actua-
tor MUST be calibrated when the following ser-
vices are performed on engines equipped with
electronic shift and throttle:
•
Replacement of throttle or shift actuator
•
Replacement of Electro Servo Module (ESM)
•
Replacement of Throttle Position Sensor (TPS)
•
Throttle or shift linkage removal/installation
•
Powerhead removal/installation
•
Gearcase removal/installation
To calibrate the actuators, use the ICON tab of the
Evinrude Diagnostics Settings screen.
In a multi-engine application, all outboards can be
calibrated through one connection. Use the
Engine Instance menu to select the engine
instance on the screen.
IMPORTANT:
If the ICON tab is not available,
make sure the engine management software has
been updated to the correct revision.
Throttle Actuator Stroke
To set throttle stroke, click the Calibrate Throttle
button. The actuator arm will move forward and
back to find the mechanical limits of the throttle
linkage.
Evinrude Diagnostics reports when the
process is complete.
Shift Actuator Stroke
To set forward gear shift stroke:
Number of
Outboards
Identity Numbers
Port Port
Center Center
S
tarboard
Center
S
tarboard
1 0
2 0 1
3 0 1 2
4 0 1 2 3
5 0 1 2 3 4

CAUTION
After installation, dealer MUST use Evinrude
Diagnostics software, version 5.1 or higher,
to calibrate the actuators for correct throttle
and shift stroke.
Failure to calibrate shift stroke will lead to
gearcase failure and possible loss of boat
control not covered by warranty.
1. Settings
2. ICON tab
3. Engine instance menu
008578
1. Calibrate Throttle button
2. Process complete message
008583
1
2
3
2
1