BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 184 / 356

Oiling System
Oil Component Servicing
184
Once hose is removed from the manifold, make
sure hose support is in the end of the hose.
Installation
Cut Replacement Oil Hose, P/N 778708, to the
correct length. Insert hose support in manifold end
of hose. (Primary manifold to rear manifold hose
does not use a hose support.)
IMPORTANT:
DO NOT insert distribution hoses
into manifold without a hose support.
Be sure the hose is fully inserted into manifold.
Insertion depth is 5/8 in. (16 mm). Visually inspect
for hose supports.
Oil Injection Pump
Removal
Disconnect the battery cables at the battery.
Remove engine cover and air silencer.
Remove the oil supply hose from the fitting (inlet)
of the oil injection pump.
Disconnect the electrical connector.
IMPORTANT:
Note oil distribution hose routings
before proceeding with disassembly. Center hose
from primary oil manifold connects to oil to inlet of
rear oil manifold.
Remove oil distribution hoses from the crankcase
fittings.
Remove oil injection pump clamp screw.
Remove the oil injection pump assembly.
Clean up any spilled oil with shop towels.
IMPORTANT:
The oil injection pump and mani-
fold is an assembly and cannot be serviced as in-
dividual components.
Installation
Route oil distribution hoses from the oil distribu-
tion manifold to the crankcase oil delivery fittings
as they were before removal. Refer to
Oil Supply
Diagrams on p. 162.
Connect oil hoses to crankcase fittings and fasten
with tie straps.
1. Hose support 008070
1
1. Clamp screw 004220
ENVIRONMENTAL NOTE
Dispose of used oil or oil contaminated towels in
an environmentally responsible manner, or
according to local regulations.
1. Crankcase fitting 004224
1
1
1