Brandt SB4000, Operator'S Manual

Page: 7 / 145

i i
___ Chemical Injection Test (if present).
1. Set up the controller as per the SideKick Manual.
2. Add RV antifreeze to the Chemical Injection Tank.
3. Divert the flow from inline mixer to the chemical injection tank.
4. Input a ground speed into the controller of approximately 5 mph.
5. Input an application rate into the Sidekick of 20 oz./acre.
6. Ensure that flow is circulating into tank.
___ Suspension Test (if present).
1. Start the tractor and engage the hydraulics. Make sure the tractor is out of gear and the park brake is
applied. Make sure the in-cab suspension switch is turned on.
2. Carefully crawl under the trailer.
3. While facing forward, grasp both the left and right upper micro switches and rotate them up and hold until the
hydraulic cylinders are fully extended. The trailer will rise up. Release the switches and the trailer should
return to the middle position. Watch your head!
4. Grasp both the left and right lower micro switches and rotate them down and hold until the hydraulic cylinders
are fully contracted. The trailer will drop down. Release the switches and the trailer should return to the
middle position. Watch your head!
Final Inspection
___ All Fasteners are tightened the appropriate amount.
___ Lubricate the machine. Refer to Section 5 of the Operator’s Manual.
___ Check the Tire Pressures. Refer to Table 8.4 of the Operator’s Manual.
___ Flush the plumbing system. See Section 3.11 of the Operator’s Manual for complete instructions.
___ Clean the Main Strainer and the Inline Filters (if present).
___ Torque wheel bolts. Refer to Table 8.4 of the Operator’s Manual.
___ Axle clamps bolts. Refer to Section 6.9 of the Operator’s Manual.
Safety Inspection
___ All safety and operational decals are installed and legible. Refer to Section 2.9 and 2.10 of the Operator’s
Manual.
___ Reflectors, Lights and SMV are clean and unobstructed.
___ Optional Light Package is operable (if present).
___ Light Package and Transportation reflectors comply with local highway and transport authorities regulations.
Customer Setups
___ Electrocution decal is installed in the tractor cab, near the Joystick
___ Boom Folding decal is installed in the tractor cab, near the Joystick
___ Adjust the flow to Hydraulic pump. Refer to Section 4.2 of Operator’s Manual for complete adjustment procedure.
___ Adjust the flow to Hydraulic block. Refer to Sections 3.3 and 3.5 of Operator’s Manual.
___ Adjust the hitch height. Refer to Section 6.1 of Operator’s Manual for complete adjustment procedure.
___ Review the Operator’s and Safety Instructions.
Date:_____________________ Dealer’s Signature: ________________________________________