Belarus 3522.5, Operator'S Manual

Page: 270 / 340

3522.5-0000010 OM
271
6.4.1.4 Task 3. Check hydraulic-brake fluid level in tanks of master cylinders of hy-
draulic drive of clutch and breaks operating control
Carry out visual inspection of the hydraulic-brake fluid level in the tank 4 (Figure
6.4.3) of the main clutch coupling cylinder and tanks 1, 2 of the main break cylinders. Level
shall be between “min” and “max” marks, made on the tanks housing. If necessary add the
hydraulic-brake fluid up to the “max” mark, having turned off the tank caps 3.
1, 2 – tank of the main brake cylinder; 3 – tank cap; 4 – tank of the main clutch cou-
pling cylinder.
6.4.1.5 Task 4. Check of hydraulic-brake fluid level in the mail cylinders housings of
clutch and breaks operating control on reverse
To check the hydraulic-brake fluid level in the mail cylinders housings of clutch 19
(Figure 3.3.4) and breaks 14 (Figure 3.9.2) operating control on reverse, it is necessary to
open housing envelopes. Liquid level shall be not less then 10…20 mm from the top edge
of the main cylinder housing on reverse, which corresponds to a size “
И
” in Figure 3.3.4
and 3.9.2. Refill the hydraulic-brake fluid up to the required level. Put the envelopes back.
ATTENTION: WHEN THE TRACTOR IS USED DURING HAULING OPERATIONS, CHECK
OF THE HYDRAULIC-BRAKE FLUID IN THE MAIN CYLINDERS HOUSINGS OF CLUTCH
AND BREAKS OPERATING CONTROL ON REVERSE,
CAN BE CARRIED OUT WITH
LESS FREQUENCY!
6.4.1.6 Task 5. Check of tires state
Carry out inspection of outside appearance and conditions of the tires in order to
detect faults or objects getting stuck in the tires (tacks, rocks and etc.,). If necessary clear
the tires of the foreign objects. In case the tires have defects going up to the tire fabric or
cracks, going through the whole tire thickness, dismount the tire and send it to the special
repair workshop for retreading. If the tires have defects is beyond repair, replace the tire. De-
fective tire shall be sent to recycling.
6.4.1.7 Task 6. Check air conditioner hose fixtures
Carry out visual inspection of air conditioner hose fixtures. Air conditioner hoses
shall be properly fixed with coupling bands. The hoses shall not be in contact with moving
parts of the tractor.
6.4.1.8 Task 7. Inspection of hydraulic system components
Carry out inspection of the tractor hydraulic system components, when the conden-
sation and downflows are detected eliminate them by means of threaded joints retorque.
6.4.1.9 Task 8. Inspect/clean air conditioner drainage pipes from the condensate
water
Light-blue drain pipes are placed to the right and to the left of the heating and cool-
ing device under the under ceiling panel. To avoid clogging the drain pipes shall be
checked and cleared when necessary. Cleanness of a drain pipe is indicated by water
dripping when the work air conditioner is used in hot weather.
https://tractormanualz.com/