Belarus 3522.5, Operator'S Manual

Page: 219 / 340

3522.5-0000010
РЭ
220
Basing on the description of the program No1, provided above, the scheme of joy-
stick control will be as shown in table 4.1:
Table 4.1 – Scheme of joystick control when creating the program No1
Joystick posi-
tion
(figure 4.2.2)
Direction of joystick movement
1
← ↑ →
2
↓ ↑
The arrows show directions of joystick movement:
↓
- backward;
←
- to the left;
→
- to the right;
↑
- forward.
For the program No2 the scheme of joystick control will be as shown in table 4.2:
Table 4.2 – Scheme of joystick control when creating the program No2
Joystick posi-
tion
(figure 4.2.2)
Direction of joystick movement
1
← ↓ →
2
↓ ↑
The availability of these schemes will allow you to orientate yourself easily when operating the
joysticks.
ATTENTION:
BEFORE THE PROGRAM NO1 IS CARRIED OUT MAKE SURE THE PLOUGH IS
IN A CORRESPONDING CONDITION – THE PLOUGH HAS BEEN TURNED TO THE
LEFT INTO ITS EXTREME POSITION, A REQUIRED WIDTH HAS BEEN SET, THE
PLOUGH HAS BEEN LOWERED INTO THE WORKING POSITION!
BEFORE THE PROGRAM NO2 IS CARRIED OUT MAKE SURE THE PLOUGH IS
IN A CORRESPONDING CONDITION – THE PLOUGH HAS BEEN TURNED TO THE
RIGHT INTO ITS EXTREME POSITION, A REQUIRED WIDTH HAS BEEN SET, THE
PLOUGH HAS BEEN LOWERED INTO THE WORKING POSITION!
To implement the recorded programs No1 and No2 during operation it is required to
carry out the following actions:
- before entering the run it is required to press the button 4 shortly (for less than two
seconds) (figure 4.2.3). The program No1 implementation will start automatically: the
plough will raise from the working position, the width will decrease to the minimum one, the
plough will start rotating from the left to the right. As the plough is in the upper (hauling)
position it is required to deviate any of the joysticks, enabled in the program, from its neu-
tral position shortly. The indicators 8, 9 will display “PAU” (pause), the annunciator 5 of the
enabled program No1 will start blinking (the program implementation will temporary stop).
In this condition it is required to drive to the edge of the field (begging of the first run) and
repeatedly push the button 4 of the program No1 to finish (continue) its implementation.
The plough continues further overturn to the right (to the working position), the width in-
creases, the plough lowers to the working position;
- when entering the run it is required to lower the first part of the plough using the
RLL control console 31 (figure 2.1.1), as this operation is impossible to program with the
OPU of the HLL;
- when driving out of the run it is required to raise the first part of the plough using
the RLL control console 31 (figure 2.1.1), as this operation is impossible to program with
the OPU of the HLL;
- press the button 3 shortly (figure 4.2.3). The program No2 implementation will
start automatically: the plough will raise from the working position, the width will decrease
https://tractormanualz.com/