Belarus 3522.5, Operator'S Manual

Page: 226 / 340

3522.5-0000010
РЭ
227
4.2.10 Rear wheel track formation
The rear wheel track is changed by moving the hub together with the wheel over the
axle shaft and by replacing the wheels from one sideboard to the other one.
To change the rear wheel track perform the following operations:
- put the tractor on a level ground, put the stops under the front and rear wheels, clean
the axle shafts from dirt;
- jack up the corresponding tube of the axle;
- release four tie bolts 1 (figure 3.14.1) of the inserts 3 and 4 (two on each insert) by
three full revolutions. The other bolts are to be screwed out. Screw the bolts of the inserts in
the thread holes for disassembly;
- if it is impossible to squeeze the inserts out with disassembly bolts 1, fill kerosene or
other liquid penetrant in places where inserts are detached from the hub body, wait for some
time and then screw the disassembly bolts in, simultaneously knocking on the hub body until
the inserts fully squeeze out;
- move the hub to a required track (use the table 4.4 to set the track “K” (figure 4.2.6) by
way of measuring the dimension “L” from the axle shaft end to the insert end face);
- screw the tie bolts out of the disassembly holes and screw them into the inserts.
Tighten the bolts with a torque of 550 to 600 N·m in several stages until all bolts are tightened
with the required torque;
- set the track for the other wheel by analogy;
- check and tighten the tie bolts after the first operation hour, then aften the first eight –
ten operation hours and after every consequtive 125 hours of operation. If the wheels were
removed during changing the rear wheel track, mounting them back tighten the securing nuts
with a torque of 700 to 750 N·m) and check the wheel securing nuts for tightening after the first
operation hour, after the first eight – ten operation hours and every subsequent 125 hours of
operation.
ATTENTION: AFTER TIGHTENING THE BOLTS MAKE SURE THE END SURFACES OF
THE UPPER AND LOWER INSERTS DON’T JUT OUT WITH RESPECT TO EACH OTHER BY A
VALUE OF 1…2 MM!
DIAGRAM 1 DIAGRAM 2
Figure 4.2.6 – Rear wheel track setting
Table 4.4 – Rear wheel track setting
Diagram No
(figure 4.2.6)
Tire size
“K” track dimensions,
mm
The installation dimen-
sion from the end sur-
face of the hub insert to
the axle shaft end “L”,
mm
1 710/70 R42 2020…2140 45…0
2 710/70 R42 2316…2576 130…0
1 650/75 R42 2020…2140 45…0
2 650/75 R42 2316…2576 130…0
ATTENTION: EX-WORKS DELIVERED REAR WHEELS WITH TIRES 710/70 R42 ARE SET TO A
TRACK UNDER THE DIAGRAM 1 (FIGURE 4.2.6), THE TRACK DIMENSION IS (2020±20) MM!
ATTENTION: EX-WORKS DELIVERED REAR WHEELS WITH TIRES 650/75 R42 ARE SET TO A
TRACK UNDER THE DIAGRAM 1 (FIGURE 4.2.6), THE TRACK DIMENSION IS (2020±20) MM!
https://tractormanualz.com/