3522.5-0000010
РЭ
207
3.26 Front wheel fenders
On the tractors BELARUS are mounted front wheel fenders with swinging mecha-
nism of lever type. This mechanism is intended for avoiding of contact between fender
and tractor frame and for avoiding of fenders damage or their destruction as a result of
such contact, this mechanism also allows not limit the turning angle of tractor wheels. The
swinging mechanism of lever type 3 allows to decrease turning angle of fenders 1 relative
to the turning angle of front wheels 2, as shown in figure 3.26.1.
1 – front wheel fender; 2 – front wheel; 3 – swinging mechanism of lever type.
Figure 3.26.1 – Operating principle of swinging mechanism of lever
1 – swinging mechanism of lever type; 2 – bolt; 3 – fender post; 4 – fender.
Figure 3.26.2 – Disassambling diagram of front whells fenders
At doubling of front wheels in order to avoid fender 4 damage and occurance of
emergency situation it is necessary to remove post 3 (figure 3.26.2) together with fenders 4
of front wheels, loosen four bolts 2. After removal of posts 3 to avoid dirtying of treated
holes build in bolts 2. At installation of fenders 4 back the bolts 2 should be tighten with
moment between 67 and 85 Nm.
TRACTOR OPERATION WITH DOUBLED FRONT WHEELS IS FORBIDDEN IF FRONT
WHEEL FENDERS ARE NOT DISMOUNTED.
IT IS FORBIDDEN TO USE FRONT WHEEL FENDERS AS SUPPORTING POINT!
https://tractormanualz.com/
Summary of Contents for 3522.5
