Belarus 3522.5, Operator'S Manual

Page: 37 / 340

3522.5-0000010
РЭ
38
“Rear PTO speed”, and switching between messages on faults are effected with “Mode”
button of the control panel (figure 2.7.2).
Samples of displaying operating parameters of the tractor on the multifunctional
display and their short description are given in table 2.3.
Table 2.3 – Samples of displaying operating parameters of the tractor on the multifunctional
display
Parameter Sample of displaying
parameter on the multi-
functional display
Parameter description
Total elapsed
engine time, h
The counter accumulates information on
the total elapsed engine time with uploading
a message “engine speed” from the engine
control unit and stores it when the power
supply is off. The range of engine time indi-
cations is from 0 to 99999.
Instant fuel flow,
l/h
In this mode a current value of the instant
fuel flow with a resolution of 0,1 l/h is dis-
played.
On-board volt-
age, V
In this mode a current value of on-board
voltage with an accuracy of 0,1 V is dis-
played in a digital form.
Remaining fuel
volume in the
tank, l
In this mode a current fuel volume remain-
ing in the tank is displayed in liters.
This mode is available only when the trac-
tor is stopped (i.e. when there are no signals
from the speed sensors).
Time of run-
ning on remain-
ing fuel, h
In this mode assessed engine time, calcu-
lated for current values of the instant fuel
flow and remaining fuel volume is displayed .
Rear PTO
speed, min
-1
In this mode a precise speed of the rear
PTO shaft end extension depending on the
signal from the rear PTO speed sensor is
displayed.
Samples of displaying fault messages on the multifunctional display and a short de-
scription of the tractor fault displayed are given in table 2.4.
https://tractormanualz.com/