– Must be performed by a technician –
– Must be performed by a technician –
113
Service
8B. Service
Test Mode
Troubleshooting
(12) Replacing the Spring or Spring Stopper – Must be performed by a technician –
z
z
In order to avoid electric shock, accident or injury to yourself or others as well as damage to the
electronic circuits, be sure to turn off the power switch before starting this task.
Turn off the power switch. (See “8A-2-3 Turning the Power Switch On” on page 77.)
Remove the control lever assembly or the throttle lever assembly. (See “8B-5-1 (6) Replacing
and Installing the Control Lever Assembly” on page 103.)
Remove the E-ring, spring end, spring and spring stopper.
Stainless steel part
Control lever
Shaft
Spring stopper
Spring
Spring end
E-ring
Replace the spring or spring stopper.
z
z
Apply silicon grease (Shin-Etsu Chemical Co., Ltd G-40M or equivalent product) to
the spring or spring stopper.
To install, perform the procedure in reverse.
z
z
When installing, be careful not to pinch the harness in the lever moving parts.
z
z
After replacement, be sure to perform initialization. (See “7-4-4 (1) I/F CALIBRATION”
on page 36.)
