Vehicle Lights and Vision
111
2
Hazard Warning Light
As shown in the figure, the hazard warning light
switch is located inside the central control
switch array.
In the event of emergency congestion, the
hazard warning light may be used to draw the
attention of other road users and avoid traffic
accidents. In the event of the following
situations, the hazard warning light should be
turned on:
1. Vehicle breaks down due to technical fault.
2.Vehicle is at the end of the vehicle flow in
traffic congestion.
3.There is emergency congestion.
4. When the vehicle tows another vehicle or is
towed by another vehicle.
After the hazard warning light is switched on,
all the turn signal lights will flash at the same
time. The two turn signal lights on the
combination instrument and the indicator light
on the hazard warning light switch will also
flash and issue a rhythmic prompting sound.
When the ignition switch is turned off, the
hazard warning lights will still work.
Caution
●
Long hours of using the hazard warning
light will consume battery power. Even when
the ignition switch is turned off, it will still
consume battery power.
●
When using the hazard warning light, be
sure to strictly follow the relevant laws and
regulations.
●
If the hazard warning light does not work,
other ways must be adopted to draw the
attention of other road users to your vehicle.
The method used must comply with the
relevant traffic laws and regulations.
Interior Lights
Reading light
The reading light is located in the middle of the
underside of the roof. As shown in the figure,
the reading light switch has a total of 3
positions:
DOOR: The reading light will be automatically
lit after the vehicle door is opened and gradually
go out after approximately 15s of continuous
lighting. Interior lights have an energy-saving
mode and will automatically go out after a
maximum length of lighting of approximately 8
minutes.
OFF: The reading light is turned off.
ON: Regardless of the state of the vehicle doors,
the reading light can belt.
