Start and drive
135
3
Start and drive
Start/stop button
The start/stop button is located in the middle of
the air conditioning vent of the center console.
Power mode switching:
Automatic transmission: Put the shift lever in
the P or N position with the brake pedal
released;
Manual transmission: When the clutch pedal is
not pressed; press the start/stop button, the
power mode will switch in the following order:
●
When the button is pressed for the first time:
the
“
RUN
”
mode is turned on, the meter is lit,
and all the powered devices such as the display
are in the on state;
●
When the button is pressed for the second
time:
“
ACC
”
mode is turned on, and the
accessory circuit such as radio and cigarette
lighter is turned on.
●
When the button is pressed for the third time:
Returns to the "OFF" mode.
Press the start/stop button one by one to cycle
through the three modes
“
OFF
”
→
“
RUN
”
→
“
ACC
”
.
Steering system
1. Do not leave the steering wheel in the dead
position (left or right) for more than 15 seconds,
which will damage the power steering system.
2. For cold zone users whose temperature is
below -20 °C, the steering fluid needs to be
replaced with a special low temperature
resistant steering fluid at the authorised
dealership.
Tips
●
Automatic transmission model: The shift
lever is in the P or N position and the brake
pedal must be depressed to start the engine.
●
Manual transmission model: The clutch
pedal must be depressed to start the engine.
For safety reasons, it is strongly
recommended to place the shift lever in the
neutral position before starting the engine.
●
Pressing the start/stop button allows the
engine to start or switch the power mode, but
the smart key must be placed in an effective
area that the vehicle can detect.