Azbil MagneW Two-wire PLUS+ MTG15A, User Manual

Page: 230 / 280

7-4
7-2. Setting and calibrating devices using the HART Communicator
The HART Communicator enables the user to set a two wired magnetic flowmeter device as
well as allowing them to adjust and check the output of the device and to inspect the device.
The following values can be set using the HART Communicator:

Flow unit

Low flow cut

Range

Drop out

Specific gravity

Pulse scale unit

Damping time constant

Pulse scale

Display selection

Pulse width

Function selection

Totalized value of integral counter display

Correction coefficient

Reset value of integral counter

Communication method

Integral counter reset

Detector diameter

High alarm value setting

Detector constant

Low alarm value setting

Auto spike cut

Setting output status setting

Average processing selection

Burnout (Analog output) setting

Average processing time

Burnout (Pulse output) setting

Electrode status diagnostic function
Also, the following calibrations and inspection can be made:

Zero point adjustment

Current output calibration at 4 mA and 20 mA

Gain adjustment

Pulse output adjustment

Excitation current output adjustment

Analog output check

Pulse output check

Contact output check

Converter status check

Tag setting

Shipping data recovery

Equipment information check
For a detailed list of all the menus, see the HART Communicator's menu table for the two
wired magnetic flowmeter at the back of this manual.