Azbil MagneW Two-wire PLUS+ MTG15A, User Manual

Page: 244 / 280

7-18
7-2-4. Pulse setting
Pulse scale unit
To set the pulse scale unit, proceed as follows:
1. From online menu,
Select:
1. Device setup

4. Detailed setup

2. Conf output

2. Pulse output

1. Puls out unit
Fig. 7-30. will then be displayed.
OK EXIT ENTER ESC ABORT DEL SAVE HOME HELP
MTGFLOW: SPL-MODE
Input another value
30 ms
30
Fig. 7-30.
2. Once the display as shown in Fig. 7-30. appears, move the arrow key up or down to select
pulse scale unit. After making a selection, press F4 (ENTER).
If F3 (ESC) is pressed here, the selection will be canceled and the display will return to the
Pulse output menu.
3. After returning to the Pulse output menu, press F2 (SEND). Changed setting will be
transmitted to the converter. The HART communicator mark will appear on the upper
right hand corner while HART is communicating with the device. The mark will
disappear once communication has properly completed.
Pulse scale
To set the pulse scale, proceed as follows:
1. From online menu,
Select:
1. Device setup

4. Detailed setup

2. Conf output

2. Pulse output

2. Puls scaling
Fig. 7-31. will then be displayed.
OK EXIT ENTER ESC ABORT DEL SAVE HOME HELP
MAGNEW2W: ** ******
Totalizer display
2037
Fig. 7-31.
2. Use the numeric keys to enter a pulse scale in the value input display.
Setting range of pulse scale is span frequency of 0.0001 Hz to 200 Hz.
3. Once a new value is entered, press F4 (ENTER) to return to the Noise immunity menu.
When the value is outside the range, error will be displayed.
Input the value again.
4. After returning to the Noise immunity menu, press F2 (SEND). Changed setting will be
transmitted to the converter. The HART communicator mark will appear on the upper
right hand corner while HART is communicating with the device. The mark will
disappear once communication has properly completed.