VENUE SC48 Guide
54
To change the Aux bus configuration:
1
Put the system in Config mode.
2
Go to the Options page and click the
Busses
tab.
3
Click
Edit
.
4
Configure the following settings:
• To link two mono Aux busses into a bus pair, select the
Link option for the corresponding pair.
• Specify the panning for channels routed to Aux bus pairs
with the
Follows Channel Pan
option.
• Click to select the pickoff point for each bus (Pre-EQ,
Pre-Mute, or Pre-Fader).
5
Click
Apply
to reconfigure the system.
– or –
Click
Cancel
to exit without changing system settings.
Solo and Monitor Operations
These settings customize Solo and Monitor bus mode and op-
eration.
Type
Solo mode choices include PFL (Pre-Fader Listen), Stereo
AFL (After-Fader Listen), and Solo-In-Place.
Auxes/Var Groups Follow AFL
Causes the controls for an Aux
Send or Variable Group Send to be automatically displayed on
the Input Channel encoders whenever the AFL switch is
pressed on the corresponding output bus.
AFL Follows Auxes
Soloes the Aux (or Variable Group) bus cur-
rently being assigned to Input encoders.
Auto Cancel
Soloing a channel strip automatically takes any
currently soloed channels out of solo.
Input Priority
Makes soloed inputs temporarily replace soloed
output busses on the AFL/PFL bus.
Mix to Monitors
Mirrors the functionality of the Mix to Moni-
tors switch on the control surface.
Level Trim
Mirrors the functionality of the Solo/PFL level con-
trol on the control surface.
Monitoring
Sets the level of the headphone output.
Delay
Sets a delay for time-aligning headphones to the house
system.
To configure Solo settings on-screen:
1
Go to the Options page and click the
Busses
tab.
2
Configure settings as needed:
To adjust Monitor Bus Delay, do one of the following:
Adjust the
Delay
encoder on-screen.
Click the
Delay
value shown on-screen, and manually enter
a new value.
To toggle Delay on or off:
Click to toggle the
Delay In
switch on-screen.
Matrixes
The Matrixes section lets you link and unlink Matrix to form
stereo Matrix busses.
Links
When enabled, these options link corresponding mono
Matrix busses into stereo-linked pairs. Control changes then
affect both mono Matrix busses.
Panning/Center Divergence
The Panning section provides control over center channel di-
vergence when the Main Bus is set to L–C–R mode. See “Main
Bus Center Divergence Options” on page 78.
To set Center Divergence:
Enter a value or drag in the Center Divergence text box and
press Enter.
Stereo Group Panning Operation
The Stereo Group Panning Operation options provide differ-
ent levels of flexibility for how channels can be routed to
Groups.
To change Stereo Group Panning Operation:
1
Put the system in Config mode.
2
Click to select
Simple
or
Expert
mode.
Solo controls in the Options > Busses page
Delay settings are retained when toggled off or on.
For more information on these features see “Solo and Mon-
itor Busses” on page 111
For more information on these features see Chapter 12,
“Matrix Mixers.”
For more information on these options, see “Simple and Ex-
pert Operational Modes” on page 85.
courtesy of
www.sxsevents.co.uk
Phone: 0870 080 2342
email: [email protected]
Event production and Audio-Visual Services
www.sxsevents.co.uk
