Chapter 11: Aux Sends
89
To route channels to Aux Sends busses using the Channel
Control section:
1
Target the first channel you want to route by pressing its Se-
lect switch.
2
Press and hold the Multi-Select switch next to the input fad-
ers, then press the Select switches on the other channels you
want to route to the Auxes.
3
In the Channel Control section, press the Aux Sends 1–8 or
Aux Sends 9–16 switch to bank the Channel Control encoders
to those Auxes.
4
Press the Channel Control encoder that corresponds to the
desired Aux Send bus so that its “On” indicator LED lights.
• The first press of an Aux Send switch assigns level control
of the odd-numbered send. The switch lights green to in-
dicate an odd-numbered selection.
• The second press of an Aux Send switch assigns level con-
trol of the even-numbered send. The switch lights yellow
to indicate an even-numbered selection.
Turn the encoder to set the Aux Send level.
To route channels to Aux Sends from the Output section:
1
Press the Auxes 1–8 or 9–16 switch to bank the Output fad-
ers to those Aux busses.
2
Press the Select switch in the Output strip for the Aux Send
to which you want to assign channels.
3
Press the Multi-Assign switch near the Output encoders. The
Multi Assign and output Select switches flash.
4
Press the Select switch on the channels you want routed to
the selected Aux Send.
5
Press the Multi Assign switch again to confirm the action.
– or –
Select another Aux Send to confirm the current assignment
but remain in Multi Assign mode to assign channels to the
newly targeted Aux bus.
Routing Aux Busses to Outputs and
Plug-Ins
Aux busses can be routed to hardware outputs and to available
bus-fed plug-ins.
To route an Aux output to the Main busses from the ACS:
1
Press an Auxes switch (1-8 or 9-16) in the Output section to
assign control of Aux levels to the Output faders.
2
Select each Aux that you want to assign to the Main busses
by pressing their Select switches.
3
In the ACS Bus Assigns section, press the L–R (left and right)
or C/Mono (center/mono) switch so that it is lit.
4
Move the channel’s fader to set the Aux output level.
Aux busses also provide Direct Outs, inserts and built-in
Graphic EQ capabilities. For details, see the following:
Direct Outs
See “Direct Outputs” on page 78.
Inserts
See “Using Inserts on Output Busses” on page 75.
Graphic EQ
See “Inserting the Built-In Graphic EQs on Output
Channel Control
1
2
3
4
5
6
7
8
Encoders
Aux Sends 1–8
Aux Sends 9–16
Auxes switches in the Output section
Auxes 1–8
Auxes 9–16
courtesy of
www.sxsevents.co.uk
Phone: 0870 080 2342
email: [email protected]
Event production and Audio-Visual Services
www.sxsevents.co.uk
