IP Office Basic Edition - Quick Mode Installation
Page 98
15-601042 Issue 24i (20 December 2011)
IP Office 8.0
6. Initial Configuration Using IP Office Manager
This section covers basic configuration changes required for IP Office systems if using the IP Office Manager application.
This covers just the basic configuration, the full range of configuration possible through IP Office Manager is covered in the
IP Office Basic Edition - Quick Mode Manager manual.
·
Entering Licenses
Enter licenses for features that require them.
·
Setting the System Locale
Setting the correct system locale affects a wide range of settings including trunk settings. The correct locale must
be set for a system to operate correctly.
·
Select Key System or PBX System Mode
The system can run in key system or PBX system modes.
·
Extension Numbering
Change the numbering mode used by the system between 2-digit and 3-digit. Renumber the user extensions if
required.
·
Change the Default Passwords
The default passwords used for configuration access to the IP Office system should be changed.
·
Change the IP Address/DHCP Settings
If necessary, the IP address and DHCP mode of the IP Office system can be changed.
99
100
101
104
103
102
