IP Office Basic Edition - Quick Mode Installation
Page 170
15-601042 Issue 24i (20 December 2011)
IP Office 8.0
9.3.3 PRI Trunk Cards
This card can be added to an IP500 base card to provide that card with support for PRI trunks. The card is available in
single port or dual port variants.
This card can be fitted to any IP500 base card.
·
Ports/Channels
1 or 2
PRI trunk ports
. Each port supports the following PRI line types.
On dual port cards, both ports will be the same line type. The line type
selection can be changed using IP Office Manager. The options available
depend on the IP Office operation mode and locale.
·
E1 PRI (30B+D channels per port).
·
E1R2 PRI (30B channels per port).
·
T1 robbed bit (24B channels per port) or T1 PRI (23B+D channels
per port).
·
The required mode can be selected within IP Office Manager by right-
clicking on the line icon and selecting Change Universal PRI Card
Line Type and then selecting the required line type.
·
Physical trunk connection is via ports 9 and 10 of the host IP500 base
card.
·
Port 11 and 12 can be used as test points for connection of test and
monitoring equipment for the adjacent port.
·
Licenses
The IP Office system supports 8 unlicensed B-channels on each IP500 PRI-U
port fitted. Additional B-channels, up to the capacity of ports installed and
PRI mode selected require IP500 Universal PRI (Additional Channels)
licenses added to the configuration. These additional channels consume the
licenses based on which additional channels are configured as in-service
from port 9 of slot 1 upwards. D-channels are not affected by licensing.
·
Maximum per Control Unit: 1 single port card per control unit. Not
supported in conjunction with BRI trunk cards in the same system.
·
Software Level: 4.1+.
Daughter Card Ports (9-12)
The LEDs for ports 9 to 12 of the IP500 base card are used as follows:
·
Off = No trunk present.
·
Green on = Trunk present.
·
Green flashing = Trunk in use.
·
Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm
indication signal (AIS) from the trunk remote end.
·
Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback
mode (set through IP Office System Monitor).
·
LED 9 is also used for daughter card status.
·
Red On = Error
·
Red Slow Flash = Initializing.
·
Red Flash every 5 seconds = Card
okay.
·
Red Fast Flash = System
shutdown.
Name
Description
SAP Code
IPO 500 TRNK PRI 1 UNI
IP Office 500 Trunk Card Primary Rate 1 Universal
700417439
IPO IP500 TRNK PRI UNVRSL SNGL TAA
" approved version for US Government contracts.
700501514
IPO 500 TRNK PRI 2 UNI
IP Office 500 Trunk Card Primary Rate 2 Universal
700417462
IPO IP500 TRNK PRI UNVSL DUAL TAA
" approved version for US Government contracts.
700501517
232
