33
EN
32
EN
Note that the following activities are unlikely to pass the System Check:
• Zipping up the jacket without wearing it
• Standing still
• Sitting down – INCLUDING sitting on the motorcycle with the engine at idle.
If the System Check is passed, a solid green (3a) LED indicator light will illuminate.
In Street Mode, the Tech-Air® 10 System is active only after having
started riding for approximately 10 seconds. Once activated, the
System remains active even if the rider stops, and until the System
is manually switched off, to offer protection also in a stationary
condition when the motorcycle is hit by a vehicle as described in the
Envelope of Protection conditions (see Section 3).
In Street Mode, you MUST ALWAYS check the LED Display (3) after
the System Check to confirm you have the solid green (3a) LED
illuminated before starting to ride/use the Tech-Air® 10 System. The
System will not deploy if a solid green LED (3a) is not present on the
LED Display (3).
WARNING!
WARNING!
d) Turning Off
Turn the System off by opening the Activation Belt (4). The System will shut down after
approximately 1 second. Confirm that the System is off by checking that the LED Display
(3) is recharging or off.
To keep the System turned off, keep the Activation Belt (4) open as shown in Figure 11.
Always keep the System in this condition while stored, transported or shipped.
ALWAYS turn the System off [by opening the Activation Belt (4)]
when you are not riding a motorcycle, even if you continue to wear
the System. Although the System has been evaluated for a number
of non-riding activities, keeping the System turned on and/or active
increases the possibility of an unwanted deployment and drains the
battery. So as a rule, when not riding, always open the Activation
Belt.
WARNING!
When not in use and being stored, transported or shipped, the System
must be turned off by leaving the Activation Belt (4) open. This
prevents the System from accidentally turning on and inadvertently
deploying, and it will preserve battery and battery life.
WARNING!
IMPORTANT!
Even when the System Check has successfully been completed, the System
will automatically turn off should the System detect:
- a rider position incompatible with the normal wearing of the System or
- no movements
for more than 10 minutes. When either of the above situations occur, open
and close the Activation Belt (4) to restart the System and perform a new
System Check.
Figure 11
