Accu AXIOM, Product Line Manual

Page: 96 / 230

96 Setup
AXIOM
™
/ AXIOM-X
™
Product Line Manual
Accu-Sort Systems, Inc. 05-AXIOM-AXIOM-X_Setup_R10.doc
I/O Options
Outputs are the most common uses for the I/O options (e.g., use to activate
diverters, beacon lights, alarms, etc. when specific conditions occur). The
only input options are to indicate an end trigger or custom signals.
Input Definition
Custom Input User-defined signal sent to AXIOM (requires custom
software)
End Trigger Only available at I/O#1 if the Trigger Source is set to
Hardware Start/End Trigger. Active when trigger signal
ends (i.e., photoeye no longer blocked).
Learn Match Code When this input is active, the AXIOM is placed into Test
Mode in order to “learn” a match code. When the line is
deactivated, Test Mode is exited. When this option is
enabled, the last code read is stored in the first entry of the
Match Table.
Height Tracking
Photoeye Used in applications requiring Height Tracking Photoeyes.
Up to three photoeyes may be used to divide the AXIOM’s
depth of field into up to four zones. The
Distance from
scanner (in inches) must also be set. (See Chapter 3. See
Mounting the Height Tracking Photoeyes.)
CAUTION: If you get this message when saving
parameters, they should be corrected before saving them.
CAUTION: If you get this message when retrieving
parameters, you should correct and save them before use.
Output Definition
Custom Output Used for applications involving custom software to select a
customized output option.
Life Light Always on while the reader is operating.
Trigger Output Echoes the status of the trigger signal.
Error Light Active in the event of an error condition (see later section
on errors currently detected).
Good Read Output Active if all expected codes are read.
No-Read Output Active if not all expected codes are read.
Match Output Active if any code matches the match code criteria.
No Match Output Active if no codes match the match code criteria (includes
no-reads).
Good Read and No-
Match Output Active if a code was read but did not match the match code
criteria.
Multiple Output Active is too many codes were read.
Multiple or NoRead
Output Active if too many codes were read or a no-read occurred.