3Com VCX V7000, Maintenance Manual

Page: 272 / 344

272 A
PPENDIX
C: U
PGRADING
VCX S
ERVER
S
OFTWARE
F
ROM
V6.0
TO
V7.0
Enter the IP address of the Master Definition site or press Enter if the
displayed address is correct. This is typically the IP address of the
primary IP Telephony server.
d The
Enter the MASTER SITE 1 IP Address [0.0.0.0]
prompt
appears.
Enter the IP address of the Master Site. This is typically the IP address
of the secondary IP Telephony server.
e The
Do you want to continue with the above settings? [n/y]:
prompt appears.
Enter
y
to continue. The script executes.
During script execution, messages appear describing the replication
setup. Messages also appear stating that firewall setup should allow
communication between the primary IP Telephony server and the
secondary IP Telephony server. These messages are a
reminder—firewall setup was performed during VCX software
installation.
f The
Have you executed the ABOVE mentioned VCX-FIREWALL
steps? [y/n]:
prompt appears.
Enter
y
to continue. The script executes.
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL . Do not continue to the next step until the
replication is complete. Note that replication can take approximately
20 minutes to complete.
g You can check the replication by entering the following command:
./checkReplication
3 When the replication is complete, enter the following command to exit
the
cworks account and return to the root account:
exit
4 Start the Authentication and Directory service on the primary IP Telephony
server and the secondary IP Telephony server by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata start
5 Start the Tomcat process on the primary IP Telephony server and the
secondary IP Telephony server by entering the following command:
./S70tomcat start