JOHNSON CONTROLS
89
SECTION 2 – OPTIVIEW CONTROL CENTER
FORM 160.79-O3
ISSUE DATE: 11/09/2018
2
This screen displays more detailed information per-
taining to the optional IEEE-519 Harmonic Filter.
There are two separate screens. One for each filter but
the information is similar.
DISPLAY ONLY
Motor Run (LED)
Indicates whether the digital output from the controls is
commanding the motor to RUN.
% Full Load Amps
Displays the motor current as a percentage of the Full
Load Amps (FLA) value. For the Variable Speed Drive
this is the data returned by the VSD Logic Board.
Motor Current Limit Setpoint
Displays the current limit value in use. This value could
come from a 0 to 20 mA, 4 to 20 mA, 0 to 10 VDC or
2 to 10 VDC input in Analog Remote mode, PWM sig-
nal in Digital Remote mode, SC-EQ communications
interface in ISN (BAS) mode, or a locally programmed
value.
VSD Model
Displays the VSD model as reported by the VSD logic
board.
Operating Mode (Run / Stop)
Indicates whether the Harmonic Filter is operating or
not.
Phase Rotation
Displays the phase rotation detected by the Harmonic
Filter (A, B, C or C, B, A).
DC Bus Voltage
Displays the DC Bus voltage as measured by the Har-
monic Filter.
Total Supply kVA
Displays the total supply kilovolt-amperes measured
by the Harmonic Filter.
Heatsink Temperature
Displays the temperature of the Harmonic Heatsink
(baseplate).
Voltage Peak (N-L1, N-L2, N-L3)
Displays the 3-phase peak voltages as measured by the
Harmonic Filter (Neutral to Line).
RMS Voltage (L1-L2, L2-L3, L3-L1)
Displays the 3-phase RMS voltages across each line.
HARMONIC FILTER DETAILS SCREEN
FIGURE 31 -
HARMONIC FILTER DETAILS SCREEN
LD27870