Watts Aerco BMK 750, Руководство по эксплуатации и обслуживанию

Страница: 64 / 157

Benchmark with Edge [I]: Operation-Maintenance Manual
SECTION 4
– INITIAL START-UP
OMM-0145_A99
• GF-218 • 9/18/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
64 of 157
NOTE:
These instructions assume that the inlet air temperature is between 50°F and 100°F (10°C
– 37.8°C)
. If NOx readings exceed the target values in Table 4-4, above, or Table 4-6, below,
increase the O
2
level up to 1% higher than the Target value. You must then record the
increased O
2
value on the Combustion Calibration sheet.
22. On Benchmark 3000 - 6000 units only , record the manifold (downstream) gas pressure at
100%. This value will be used in Section 5.2.2: Low Pressure Gas Test , and Section 5.3.2:
High Pressure Gas Test .
23. Once the O
2
level is within the specified range at 100%:
•
Enter the Flame Strength , NOx and CO readings from the Combustion Analyzer
and multi-
meter in the Manual Combustion Calibration screen’s
Reading column.
•
Enter the same values, plus the O
2
value, on the Combustion Calibration Data Sheet
provided with the unit.
24. Lower the Valve Position to the next calibration point using the

(Left) arrow key (if using
Method 1 in step 11) or the Fine Valve Position
– (Minus) key (if using Method 2).
•
BMK750P & 1000P: 80%
•
BMK1500/2000/2500 DF & P: 70%
•
BMK3000 DF & P: 85%
•
BMK5000P & 6000P: 70%
•
BMK5000DF & 6000DF: 85%
25. Repeat step 17, 18 and 21 at that valve position and the rest of the valve positions in Table
Table 4-6a and 4-6b, depending on model. The O
2
, NOx and CO should stay within the
ranges shown in these tables.
TABLE 4-6a: PROPANE Final Valve Positions: BMK750 – 3000
Valve Position Oxygen (O
2
) % Nitrogen oxide (NOx) Carbon Monoxide (CO)
BMK750/1000
80% 5.5% ± 0.2% <100 ppm <150 ppm
60% 5.5% ± 0.2%
<100 ppm
<150 ppm
45% 5.5% ± 0.2%
<100 ppm
<150 ppm
30% 6.3% ± 0.2% <100 ppm <100 ppm
18% 5.5% ± 0.2%
<100 ppm
<100 ppm
BMK1500
70% 5.2% ± 0.2%
<100 ppm
<150 ppm
50%
5.3% ± 0.2%
<100 ppm
<150 ppm
40%
6.2% ± 0.2%
<100 ppm <150 ppm
30%
7.0% ± 0.2%
<100 ppm
<100 ppm
18%
8.5% ± 0.2%
<100 ppm <100 ppm
BMK2000
70% 6.5% ± 0.2%
<100 ppm
<150 ppm
50%
6.5% ± 0.2%
<100 ppm <150 ppm
40%
6.5% ± 0.2%
<100 ppm
<150 ppm
30%
6.5% ± 0.2%
<100 ppm <100 ppm
18%
5.5% ± 0.2%
<100 ppm
<100 ppm