Benchmark with Edge [I]: Operation-Maintenance Manual
SECTION 2: OPERATION
OMM-0145_A99
• GF-218 • 9/18/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
13
of
157
SECTION 2.
EDGE [I] CONTROLLER OPERATION
2.1 INTRODUCTION
This section provides a brief outline of how to gain access to Benchmark Boiler
’s Edge [i]
Controller functionality. Full instructions for using the Edge [i] Controller to setup, configure and
operate a Benchmark Boiler are included in the
Edge [i] Controller Manual
, OMM-0141, GF-213-
B
The Edge [i] Controller is shown below. This panel contains all of the controls, indicators and
displays necessary to operate, adjust and troubleshoot the boiler.
The Edge [i] Controller
’s front panel consists of a touchscreen display along with a variety of
indicators and buttons.
Figure 2-1 Edge [i] Controller Front Panel
1
Multi-Function Bar, shows either:
•
Fire Rate
•
Valve Position
2
Parameter Indicator for both temperature
read-outs:
•
LEFT:
Inlet
or
Setpoint temperature
•
RIGHT:
Outlet
or
System Header
temperature
3
Temperature scale indicator: Fahrenheit
or Celsius
4
Configurable temperature read-outs (2):
•
LEFT:
Inlet
or
Setpoint
temperature
•
RIGHT:
Outlet
or S
ystem Header
temperature
5
Operation Mode Indicators (2):
•
LEFT:
Demand
or
Manual
•
RIGHT:
Manager
or
Client
(BST
only)
6
Edge [i] Controller Touchscreen
7
Soft Keys
8
onAER Indicator Light
9
Ready Light
10
Enable/Disable Switch
11
Low Water Level Buttons (2):
•
TEST
: Initiates Low Water test
•
RESET
: Resets unit after Low Water
test
1
2
3
6
7
10
11
4
5
9
8
