Telstra Commander i, Руководство по обслуживанию

Страница: 47 / 195

Hardware Installation
Commander i+ Product Service Manual - Issue 2 Page 3-23
Connection of
Internal BUS Cable
Open the sliding cover to access the internal socket.
•
Plug the 6-wire AFU Bus Cord into this socket.
Connection of
Analogue
Terminals
(cordless, fax,
answering
machines etc)
To Connect Using RJ12 Jacks:
•
Close the sliding cover.
•
Connect the telephone(s) using the two modular RJ12 jacks.
The extension interfaces are equipped with internal protection against
power surges. However, for increased safety in the case of outdoor
installations, it is advisable to use specific protection devices (eg. gas
dischargers).
Connection of AFU
Plugpack
•
Close the cover (this is most important).
•
Insert the power cord of the AFU plugpack (supplied with a four pin
plug) into the power connector socket on the front left-hand side of
the AFU.
IMPORTANT NOTE: When connecting the AFU plugpack to the
mains, you have five seconds to start-up the initial configuration
(or to re-start a new configuration). Refer to System initialisation -
AFU Numbering.
AFU Fax Switch
i+ AFU only
Note: The i+ AFU has not been formally released by Telstra at the
time of publication.
The AFU has fax switch functionality that allows inter-working
between an answering machine and fax machine. If a call routed to the
answering machine is a fax call then the AFU detects that the call is a
fax call and automatically transfers the call to the fax machine.