SystemAir REPT10, Руководство по эксплуатации

Страница: 47 / 67

Display
STOP
for switch OFF
•
Controller
“ ON ”
for closed contact
(factory setting).
•
Controller
“ OFF ”
with opened con-
tact
When inverting in reverse i.e. equipment
“ OFF ” with closed contact.
D1 D1 D1 D1
Digital IN 1 Digital IN 1
ON OFF
10.05.2007
v_1d_freigabe_d1_d1.vsd
Contact at digital input e.g. “ Digital In 1 ”
Attention!
No disconnection when turned off (no isolation in accordance with VBG4
§
6)!
9.9.3.3 External fault Function
|
2D
|
Connecting an external alarm indication (via fl oating contact). The device continues to work un-
changed during an external indication to the digital input; the alarm symbol appears in the display.
This indication can be issued via the relay contacts (K1, K2) (
IO Setup function K1, K2).
Example for connecting an external alarm indication e.g. to digital input “ Digital In 1 ”
Controller
1~ S-ET..
3~ STDT..
TB
TB
TB
K1
D1
D1
10.05.2007
v_2d_externe_stoerung_set_stdt.vsd
1~ S-ET..
3~ STDT.. 1~ S-ET..
3~ STDT..
•
Indication during closed contact (factory setting): “ D1 Inverting ” = “ OFF ”
•
Indication during opened contact: “ D1 Inverting ” = “ ON ”
Actual value
Alarm symbol for indication “ External fault ”
9.9.3.4 Limit ON / OFF, Function
|
3D
|
The value for “ Limit ” adjusted in the Controller Setup, is activated over a digital input.
Contact e.g. at ditgital input “ Digital In 1 ” (depending on device type at terminals “ D1 ” - “ D1 ” or “ D1 ” -
“ 24 V ” ).
For “ D1 ” Inverting “ OFF ” , limitation active at closed contact.
Operating Instructions
REPT6 / REPT10
Programming
L-BAL-E081-GB 1237 Index 002 Part.-No. 00163316-GB
47/67