6.4
Menu structure
PIN
0010
STOP
←
←
←
←
User
Service
→
→
→
→
Start
▼
▲
Info
▼
▲
Setting
▼
▲
Events
▼
▲
Base setup
P
↓
↑
ESC
P
↓
↑
ESC
P
↓
↑
ESC
P
↓
↑
ESC
P
↓
↑
ESC
PIN input
E1 Actual
Setpoint1
Motor fault
Mode
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
E2 Actual
Setpoint2
E1 Analog In
Menu dependent on device type
Selection of the menu group (e.g. Base setup) to the right through the
▼
-key, to the left through the
▼
-key.
You can go to the menu items in the menu groups (e.g. mode of operation) by using the
P
key. Use
the arrow keys to move up and down within the menu group.
The menu groups consist of one area for the user (user menu) and one area for installation (service).
The service area can be protected against unauthorized access by using a PIN.
In order to simplify the initial start-up operation, the service level is enabled at
fi
rst (i.e., not protected
by the PIN 0010 (
see Controller Setup, PIN protection = OFF). If PIN protection is activated (ON),
the service menu remains enabled after input of PIN 0010 as long as one is pressing keys. If no keys
are pressed for ca. 15 minutes, the PIN is automatically erased, i.e. the service level is blocked.
To make adjustments, press the
P
key after selecting the menu item. If the previously set value starts
to
fl
ash, it can be adjusted with the
▼
+
▲
keys and then saved with the
P
key. To exit the menu
without making any changes, use the
“
Esc
”
short-key, i.e., the originally set values remain.
Information
After installation of the device has been carried out, PIN protection should be activated (
Controller
Setup)!
6.5
Example for programming mode
2.01
in
“
Base setup
”
1
2
3
4
5
6
7
Mode
P
Mode
▲
Mode
P
Mode
Operating Instructions
REPT6 / REPT10
Controls and Menu
L-BAL-E081-GB 1237 Index 002
Part.-No. 00163316-GB
16/67
