SystemAir REPT10, Руководство по эксплуатации

Страница: 62 / 67

Motor fault
Controllers period of operation at time of message:
With the
P
key can be switched between description of the
message and the Controllers period of operation at this time.
E.G. on place 3 which is past message
motor fault .
00009:01:08
11.2 Messages and trouble shooting
A momentary pending alarm or error message is indicated by a blinking indicator and appears
alternately with the standard display.
Display Code* Relais switches ** Cause Reaction of Controller
Operation Fault Adjustment
Line voltage available?
Unit switch OFF and automatically
ON when the voltage has been re-
stored
check internal controller fuse
X - No enable Switch OFF by external contact
(function
|
1D
|
= enable programmed
for Digital In)
Factory sett.
AL - - fault in Eprom works with defaults
EEP error
AL - X fault EEP damaged works with defaults
EEP Corruption
AL X X EEP data incorrectly controller runs with the read settings
External error
AL -
selecta-
ble
Alarm from external contact
Device continues working un-
changed
check contacts
Lmt E1 min
AL -
selecta-
ble
Limit indication minimum
Actual value below setting
“ Alarm Minimum ” (Input “ E1 ” )
Device continues working un-
changed
Check setting and sensor
Lmt E1 max.
AL - selecta-
ble
Limit indication maximum
Actual value above setting
“ Alarm Maximum ” (Input “ E1 ” )
Sensor 1
Msg or.
AL*
selecta-
ble
selecta-
ble
Interruption / short circuit in the
sensor leads or sensor values
measured are outside measur-
ing range
The device works with minimal or
maximum modulation depending on
whether there is a short-circuit or an
interruption, and on the programmed
mode of operation.
Check sensor
Motor fault
Err X X
Tripping of connected thermo-
stat or break between terminals
“
TB
”
.
The unit then remains switched off.
A programmed operating and fault-
indicating relay is triggering
Check motor and connection then
reset
*Code: Err = Error, Al = Alarm, Msg = Message
** Relais switches dependent on programmed function
Operating Instructions
REPT6 / REPT10
Events / Fault signals
L-BAL-E081-GB 1237 Index 002 Part.-No. 00163316-GB
62/67