SystemAir REPT10, Руководство по эксплуатации

Страница: 50 / 67

Controller
24V
D1 D1
1 0
n = 0 -100 %
1
n = 80 %
0
- - - - -
- - - - - - - - - -
Se
E1
ES E2
26.05.2010
v_7d_regelung_hand.vsd
3
2
1
1 Setting “ Setpoint1 ”
2 Setting “ Setpoint2 ”
3 Setting “ Speed manual ” (depending on device type in: %, Hz, rpm)
EH Signal for Manual mode extern, E2 Function =
|
2E
|
Se Sensor
• “ D1 Inverting ”
=
“ OFF ”
Automatic
control at opened contact / manual
operation at closed contact.
• “ D1 Inverting ”
=
“ ON ”
: Automatic control
at closed contact / manual operation at
opened contact.
9.9.3.9 Reverse action of control function (
2.01
), Function
|
8D
|
Switchover between: Increasing modulation during increasing actual-value and increasing modulation
during sinking actual-value.
The factory presets for the
“ Control function ” are dependent on the selected mode of operation (
Controller Setup - reverse operation of the control function).
When switching over via a digital input, the device works with the opposite function than the one set
there!
Val>Set=n+
Settings in Controller Setup
9.9.3.10 Reset, Function
|
10D
|
Reset after motor fault by using an non-locking reset key. The unit switches off when interruption
between both
“ TB/TP ” or “ TK/PTC ” terminals, the unit then remains switched off ( “ motor fault ” see
motor protection). Re-starting after the drive has cooled down (terminals “ TB/TP ” - or “ TK/PTC ”
bridged) by non-locking reset key possible.
Contact at digital input e.g. “ Digital In 1 ”
•
For
“ D1 Inverting ”
=
“ OFF ”
both
terminals
“ D1 ”
-
“ D1 ”
in normal operation
interrupted. Reset after fault by short
close.(For
“ Inverting ”
=
“ ON ”
reverse
function).
9.9.3.11 Setting Max. Speed ON / OFF function
|
11D
|
The value for “ Max Speed ” adjusted in menu “ Settings ” , is activated over a digital input. I.e. the unit
works independently of the controller function fi rm with this value.
Contact e.g. at ditgital input “ Digital In 1 ” (depending on device type at terminals “ D1 ” - “ D1 ” or “ D1 ” -
“ 24 V ” ).
Operating Instructions
REPT6 / REPT10
Programming
L-BAL-E081-GB 1237 Index 002 Part.-No. 00163316-GB
50/67