9.7
Menu group Info
Info
Menu group Info
Info for mode speed controller
1.01
Modulation
Device modulation.
In addition to the bar chart, the level of the output voltage with the connected load is
indicated as a percentage.
Set external1
Display of the currently active default signal.
The percentage corresponds to the internal actuation of the power component under
consideration of the settings
“
Min. speed
”
and
“
Max. speed
”
.
0 - 100 %
0 - 10 V, 10 - 0 V, 0 - 20 mA, 20 - 0 mA, 4 - 20 mA, 20 - 4 mA
Display:
The device operates at:
“
Set external1
”
Signal to
“
E1
”
/
“
GND
”
“
Set external2
”
Signal to
“
E2
”
/
“
GND
”
“
Set Intern1
”
Menu
“
Set Intern1
”
“
Set Intern2
”
Menu
“
Set Intern2
”
Info for mode controller
2.01
...
6.01
E1 Actual
Current actual value measured on the sensor 1.
Depending sensor-type in: mbr, m
3
/s, m/s, Pa, %, bar, m
3
/h,
°
C, V, mA, etc.
E2 Actual
For operation with two sensors display for
“
2 actual
”
.
If function not active, display
|
- - - - -
|
Setpoint1
Display of the active target value at which the device operates.
“
Setpoint1
”
Menu
“
Setting
”
“
Setpoint2
”
Menu
“
Setting
”
“
Ext. Setpoint
”
= setting by external signal 0-10 V. With activated manual mode the
display constantly changes between actual value and value for manual mode.
Modulation
Device modulation.
In addition to the bar chart, the level of the output voltage with the connected load is
indicated as a percentage.
Min. speed cut off
Momentarily status for minimum speed cut off
“
ON
”
= switch off, if Setpoint (+/-
“
Min. speed cut off
”
) is reached.
“
OFF
”
= no switch off that means operation with minimum rate of air.
Operating Instructions
REPT6 / REPT10
Programming
L-BAL-E081-GB 1237 Index 002
Part.-No. 00163316-GB
39/67
