Siemens SIMATIC ET 200AL, Системное руководство

Страница: 389 / 2255

DI 8x24VDC 4xM12 (6ES7141-5AF00-0BA0)
24
Equipment Manual, 08/2021, A5E36680963-AB
PROFIenergy
7
7.1 Pause function
Introduction
PROFIenergy is a PROFINET-based data interface for switching off consumers centrally and in
a coordinated manner during pause times regardless of the manufacturer or device type. This
has the aim that the process is only provided with the energy that is absolutely required. The
majority of the energy is saved by the process itself; the PROFINET device itself only
contributes a few watts of saving potential. In PROFIenergy, this operating state is referred to
as a "pause".
Start and end of a pause
You enable and disable the pause function of the system at the beginning and end of pauses,
respectively; the IO controller then sends the PROFIenergy command "Start_Pause" or
"End_Pause" to the modules.
Use the "Start_Pause" command to start a pause.
Use the "End_Pause" command to end a pause.
The following conditions will also cause a pause to be ended:
•
Reconfiguration in RUN
• Controller failure
• Firmware update
• Station stop
• Restart of the interface module through:
– POWER OFF/POWER ON of an interface module
– POWER OFF/POWER ON of an I/O module
– Termination of ET-Connection1 or ET-Connection2
The specific behavior of the digital input module is explained in the following section.
Additional information
You can find additional information on working with PROFIenergy in the "PROFIenergy"
section of the manual IM 157-1 PN interface module
( https://support.industry.siemens.com/cs/ww/en/view/89254863 ) and the "Saving energy
with PROFIenergy" section of function manual PROFINET with STEP 7 V13
( https://support.industry.siemens.com/cs/ww/en/view/49948856 ).
Application examples ( https://support.industry.siemens.com/cs/ww/en/view/41986454 ) are
also available on the Internet.