Red Hat ENTERPRISE LINUX 5 - VIRTUAL SERVER ADMINISTRATION, Руководство по установке

Страница: 202 / 388

Chapter 16. Steps to Get You Started
184
•
NETMASK= netmask
Where
netmask
is the netmask.
•
BROADCAST= broadcast
Where
broadcast
is the broadcast address.
•
GATEWAY= gw
Where
gw
is the gateway-IP for your
eth
device.
•
MTU= mtu
Where
mtu
is the Maximum Transmission Unit (MTU) for this connection.
•
DNS= server1 : server2 :: serverN
Where
server1 : server2 :: serverN
is a list of DNS servers, separated by colons. For example:
DNS=10.0.0.1:10.0.0.2
•
SEARCHDNS= domain1 : domain2 :: domainN
Where
domain1 : domain2 :: domainN
is a list of the search domains, separated by colons. For
example:
SEARCHDNS=example.com:example.org
•
PORTNAME= osa_portname
|
lcs_portnumber
This variable supports OSA devices operating in qdio mode or non-qdio mode.
When using qdio mode:
osa_portname
is the portname specified on the OSA device when
operating in qeth mode. PORTNAME is only required for z/VM 4.3 or older without APARs VM63308
and PQ73878.
When using non-qdio mode:
lcs_portnumber
is used to pass the relative port number as integer
in the range of 0 through 15.
•
FCP_n="device_number SCSI_ID WWPN SCSI_LUN FCP_LUN"
The variables can be used on systems with FCP devices to preconfigure the FCP setup and can be
subsequently edited in anaconda during the installation. An example value may look similar to:
FCP_1="0.0.5000 0x01 0x5105074308c212e9 0x0 4010"
•
n
is an integer value (e.g.
FCP_1
,
FCP_2
, ...).
•
device_number
is used to specify the address of the FCP device (
0.0.5000
for device 5000,
for example).
•
SCSI_ID
is specified in hex-value, typically sequential values (e.g.
0x01
,
0x02
... ) are used over
multiple FCP_ variables.