Red Hat ENTERPRISE LINUX 5 - VIRTUAL SERVER ADMINISTRATION, Руководство по установке

Страница: 158 / 388

Chapter 12. Installing on IBM System i and IBM System p systems
140
Figure 12.18. Creating a New Partition
•
Mount Point
: Enter the partition's mount point. For example, if this partition should be the root
partition, enter
/
; enter
/boot
for the
/boot
partition, and so on. You can also use the pull-down
menu to choose the correct mount point for your partition. For a swap partition the mount point
should not be set - setting the filesystem type to swap is sufficient.
•
File System Type
: Using the pull-down menu, select the appropriate file system type for this
partition. For more information on file system types, refer to
Section 12.19.5.1, “File System Types”
.
•
Allowable Drives
: This field contains a list of the hard disks installed on your system. If a hard
disk's box is highlighted, then a desired partition can be created on that hard disk. If the box is
not
checked, then the partition will
never
be created on that hard disk. By using different checkbox
settings, you can have
Disk Druid
place partitions where you need them, or let
Disk Druid
decide
where partitions should go.
•
Size (MB)
: Enter the size (in megabytes) of the partition. Note, this field starts with 100 MB; unless
changed, only a 100 MB partition will be created.
•
Additional Size Options
: Choose whether to keep this partition at a fixed size, to allow it to
"grow" (fill up the available hard drive space) to a certain point, or to allow it to grow to fill any
remaining hard drive space available.