Chapter 7 Installing, Removing, and Replacing
Adding Expansion Modules to an Existing Library
Scalar i500 User’s Guide
222
5
Open the module’s access door and raise the guide pin by pulling it
up and turning it slightly as if it were a screw. Otherwise, the guide
pin may scratch the front doors of the module beneath it.
6
From the front of the library, slide the entire module toward you and
lift it off of the module below it.
7
Repeat these steps for each module that you need to remove.
Installing the New 9U
Expansion Module
7
Install the new 9U expansion module as follows:
1
Prepare the rack to hold modules, if you want to install your library
in a rack. See
Installing the Library in a Rack
on page 284 for
instructions on installing a rackmount kit.
1
Guide pin
2
Thumbscrew