Chapter 3 Configuring Your Library
Configuring the Internal Network
Scalar i500 User’s Guide
118
Configuring the Internal Network
Use the
Internal Network Configuration
screen to configure your library’s
internal network setting. The default internal network address is
10.10.10.X
.
The library’s internal network enables communication among library
components. While rare, it is possible that the default addressing of the
internal network could conflict with your network, potentially causing
the library to become confused. When installing the library, make sure
that the external network setting is different from the internal network
setting on the library. If DHCP is enabled or you do not know what your
external network setting is, check with your network administrator.
From the operator panel, administrative users can change the setting of
the internal network using the
Internal Network Configuration
screen.
Select the new internal IP address from the list on the screen. You can
select from nine IP addresses.
The
Internal Network Configuration
screen is only accessible from the
operator panel. The path to open the appropriate screen is as follows:
• From the operator panel, select
Tools > Internal Network
.
Configuring System Settings
You can use the operator panel
System Settings
screen to configure the
following system-wide settings:
•
User session timeout (minutes)
— The library automatically logs out a
user or administrative user when the library has detected no activity
for a specified length of time. You can adjust the user session timeout
by entering a numeric value in the
User session timeout (minutes)
text
box. Valid user session timeout values are 15 minutes to 480 minutes.
•
Touch screen audio
— Allows you to enable or disable the beep sound
that occurs each time you press a button on the operator panel. The
Touch screen audio
setting is enabled by default.
