Polaris 2014 Sportsman 570 EF, Руководство по обслуживанию

Страница: 429 / 456

10
10.49
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
Hazard / Flasher Module
The flasher module functions directly from the battery
supply. Hazard lights are functional regardless if the
ignition is on or off. Switching the flash output to left or
right side turn signals will flash the lights accordingly. The
hazard terminal is designed for a SPST switch to connect
it to the flash output. Closing this switch will connect the
flasher driver output to both left and right turn signal
lights via two diodes. While the ignition is on, the flash
driver will be toggling on and off regardless of turn or
hazard switch position. If ignition is off, the flasher driver
will remain off until a lamp load is connected (turn or
hazards on) to reduce current draw. Two or more lamps
connected to the flash output will flash at the normal rate
in turn or hazard mode. The flash rate will double when a
single lamp is detected on the flash output in turn or
hazard mode.
Rear Tail Lamp / Turn Signal Lamp
Replacement
The turn lamp (A) and the tail lamp (B) are both located
in the rear lamp housing.
1. To remove the turn lamp electrical connector (A), pull
down on the connector lock and pull the connector
from the bulb assembly.
2. To remove the tail lamp electrical connector (B),
press in on the tab on the connector to unlock the
connector and pull the connector from the bulb
assembly.
3. To exchange either of the bulbs, turn the housing 1/4
turn counter-clockwise to remove and install. Turn
the housing clockwise to install.
ELECTRICAL