Polaris 2014 Sportsman 570 EF, Руководство по обслуживанию

Страница: 168 / 456

4.22
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
TEMP / MANIFOLD ABSOLUTE PRESSURE SENSOR (T-MAP)
Operation Overview
Mounted on the throttle body intake manifold, the T-MAP
sensor performs two functions in one unit.
Air passing through the intake is measured by the T-MAP
and relayed to the ECU. These signals, comprised of
separate air temperature and manifold absolute pressure
readings, are processed by the ECU and compared to its
programming for determining the fuel and ignition
requirements during operation. The T-MAP sensor
provides the ECU with engine load data.
T-MAP Sensor Test
The T-MAP sensor is a non-serviceable item. If it is
faulty, it must be replaced.
NOTE: This sensor should only be tested using the
Digital Wrench Diagnostic Software (dealer only).
T-MAP Sensor Replacement
1. Disconnect the negative (-) battery cable.
2. Remove the right side panel.
3. Disconnect vehicle harness from T-MAP sensor.
4. Remove the retaining bolt and remove the sensor
from the intake boot.
5. Use a light coating of soapy water on the grommet to
aid installation of the new sensor.
6. Install the sensor by inserting it with a twisting motion
to properly seat the grommet.
7. Install the retaining bolt and torque to specification.
T-MAP Retaining Bolt:
24 in-lbs (2.8 Nm)
FUEL SYSTEM - GENERAL