nord NORDAC SK 200E, Руководство пользователя

Страница: 58 / 180

NORDAC SK 200E Manual
58 Subject to technical alterations BU 0200 GB
Display
Error
Cause

Remedy
Identification errors
220
UNKNOWN DEVICE
Device ID not found. The connected inverter is not listed in the database of
the ParameterBox; no communication can be established.
 ParameterBox is too old for the FI.

Please contact your Getriebebau Nord Representative.
221
SOFTWARE VERSION NOT
RECOGNISED
Software version was not found. The software of the connected frequency
inverter is not listed in the ParameterBox database, no communication can
be established.
 Please contact your Getriebebau Nord Representative.
222
CONFIGURATION STAGE NOT
RECOGNISED
An unknown component has been detected in the frequency inverter
(Customer interface).
 Please check the components installed in the frequency inverter
 If necessary, check the software version of the ParameterBox and the
frequency inverter.
223
BUS CONFIGURATION HAS
CHANGED
After restoring the last Bus configuration, a device is reported that is different
from the one stored. This error can only occur if the parameter >Auto. Bus
Scan< is set to OFF and another device has been connected to the
ParameterBox.
 Activate the Automatic Bus Scan function.
224
DEVICE NOT SUPPORTED
The inverter type entered in the ParameterBox is not supported!
 The ParameterBox cannot be used with this inverter.
225
THE CONNECTION TO THE
INVERTER IS BLOCKED
Access to a device that is not online (previously Time Out error).
 Carry out a bus scan via the parameter >Bus Scan< (P1001).
ParameterBox operating error
226
SOURCE AND TARGET ARE
DIFFERENT DEVICES
Copying objects of different types (from / to different inverters) is not
possible.
227
SOURCE IS EMPTY
Copying of data from a deleted (empty) storage medium
228
THIS COMBINATION IS NOT
PERMITTED
Target and source for the copying function are the same. The command
cannot be carried out.
229
THE SELECTED ITEM IS EMPTY
Parameterisation attempt of a deleted storage medium
230
DIFFERENT SOFTWARE VERSIONS
Warning:
Copying objects with different software versions can cause problems when
transferring parameters.