nord NORDAC SK 200E, Руководство пользователя

Страница: 46 / 180

NORDAC SK 200E Manual
46 Subject to technical alterations BU 0200 GB
Control with the SimpleBox
The frequency inverter can only be controlled via the SimpleBox, if it has not previously been enabled via
the control terminals or via a serial interface (P509 = 0 and P510 = 0).
If the START key is pressed, the frequency inverter changes to the operating display (selection P001). The
frequency inverter supplies 0Hz or a higher minimum frequency (P104) or jog frequency (P113) which has
been set.
STOP
Store current frequency
as jog frequency
Set frequency = 0Hz
(press simultaneously)
Increase frequency
Change rotation direction
Decrease frequency
START
Parameter set display
Quick stop
(press simultaneously)
Parameter set display:
The LEDs indicate the actual operating parameter set in the operating display (P000) and the current
parameter set being parameterised (

P000). There, the display appears in binary form.
The parameter set can also be changed during operation via the parameter P100, if control is by means of
the SimpleBox.
Frequency setpoint:
The current frequency setpoint depends on the setting in the parameters jog frequency (P113) and minimum
frequency (P104). This value can be altered during keyboard operation with the value keys
and
permanently stored in P113 as the jog frequency by pressing the OK key
OK
.
Quick stop:
A quick stop can be triggered by simultaneously pressing the STOP key and the "Change direction key” .