NF FRA51602, Инструкция по эксплуатации

Страница: 230 / 286

7.2 Information messages
7
-
6
FRA 51602
7.2 Information messages
Measurements that may be displayed when operations or measurements are completed normally are
explained in this section.
An example information message is presented below. The message code follows "Message:" in the
information window. In the example shown below, the message code is "2048". Please note that message
codes differ from error codes in that error codes are preceded by a minus sign. (See "
7.1 Error
messages
".)
7.2.1 Messages presented at start-up
Messages that may be presented when the power is turned on are listed in
Table 7-5
.
Table 7-5 Messages presented at start-up
No. Message Description
1024 Settings have been initialized due to
firmware update.
All settings were initialized after a firmware
update was performed.
1025 Last shutdown caused by power failure. The previous time the instrument was powered
down, power was turned off without first entering
the standby state, so the instrument started up
with the settings loaded from setting memory
No.1.
7.2.2 Messages presented during operation
The messages that may be presented during normal operation are listed in Table 7-6 .
Table 7-6 Messages presented during operation
No. Message
Description
100 Are you sure you want to reset the current
LAN settings?
Confirmation for a LAN reset operation.
101 Interface setting in progress. The remote interface set-up is in progress.
2048 Done. The operation has been completed.
3072 Are you sure you want to delete the MEAS
TRACE?
Confirmation for clearing the measurement data
trace.
3073 Are you sure you want to execute the
"CALIBRATION"?
Confirmation for executing calibration.