NF FRA51602, Инструкция по эксплуатации

Страница: 220 / 286

6.3 Measurement conditions file format
6
-
6
FRA 51602
6.3 Measurement conditions file format
The measurement conditions file is in text format (TXT) and can be accessed by text editors or spreadsheet
software, etc. The file timestamp indicates the time the file was saved.
The structure of the measurement data file is illustrated below.
Beginning of file Header
Measurement
conditions
End of file
Figure 6-3 Structure of the measurement conditions file
Table 6-4 Measurement conditions file format (header)
Line
number Format (example) Description
1 IDN, NF Corporation, FRA51602,
0123456, Ver1.00
Manufacturer, model,
serial number, firmware version
2 FileFormatVer, 1.00 File format version
3 FileType, CON File type (setting data)
Table 6-5 Measurement conditions file format (measurement conditions part)
Line
number Format (example) Description
4 Sequence, (NR1) The sequence sweep number (0 – 20)
5 OscFrequency, (NR2) The oscillator frequency (Hz)
6 OscAmplitude, (NR3) The OSC amplitude (Vpk)
7 OscDCbias, (NR2) The OSC DC bias (V)
8 OscOutputConnector,
{FRONT|REAR}
The DC bias output connector
9 OscOnOffSync, {ASYNC|SYNC} Measurement synchronization
10 OscOnOffMode, {QUICK|SLOW} The on/off mode
11 OscStopMode, {QUICK|SYNC} The oscillator stop mode
12 OscWaveForm,
{SINE|SQUARE|TRIANGLE}
The oscillator waveform
13 Osc10MHzRefIn,
{DISABLE|ENABLE}
Selects the reference clock
Internal clock only (DISABLE),
External clock enabled (ENABLE)
14 Osc10MHzRefOut,
{DISABLE|ENABLE}
Sets the reference clock output
Disabled (DISABLE),
Enabled (ENABLE)
15 AmplitudeCompression, {ON|OFF} Sets the amplitude compression function
to enabled (ON) or disabled (OFF)