NF FRA51602, Инструкция по эксплуатации

Страница: 227 / 286

7.1 Error messages
7
-
3
FRA 51602
7.1.2 Errors that occur during panel operation
The errors that may occur during panel operation are listed in
Table 7-2
.
Table 7-2 Panel operation errors
No. Error message Description and cause Handling
-2048 Data out of range. The set parameter value lies outside
the specified range.
Set a value that is within the
correct range.
-2049 Settings conflict. There is a violation of constraints
among multiple settings.
Set a value that is within the
correct range.
-2050 Not allowed character. An invalid character has been
entered.
Enter only valid characters.
-2051 String length error. The permitted number of characters
has been exceeded.
Reduce the number of
characters to the permitted
number.
-2052 Execution error. Execution was prevented by
constraint conflicts among multiple
settings.
Change the settings so that
the constraint conditions are
satisfied.
-2053 Syntax error. There is an error in the numerical
input.
Input a correct expression
-3073 Insufficient data for
equalize correction. It may
not work correctly.
There is insufficient equalizing
correction data. The equalizing
correction may not succeed.
Prepare a sufficient amount
of correction data.
-3077 Can't execute calibration.
Please turn off the
oscillator output.
The calibration process cannot
begin because the oscillator output
is turned on.
Turn the oscillator output
off and start the calibration
again.
-5120 Printer didn't respond. There was no response from the
printer.
Connect the specified
printer.
-5121 Out of paper The printer has run out of paper. Refill the printer paper
supply.
-6144 Can't access USB storage. Access to the USB memory device
failed.

Connect a proper USB
memory device.

Make sure the USB
memory device is securely
connected.