NF EC1000SA, Инструкция по эксплуатации

Страница: 92 / 283

4.4 Using the Sequence Function
EC1000SA 4-24
The step transition parameters specify the next step and its timing.
Table4-5. Step Transition Parameters
[Step time] Specified in time
[Step end phase] Sets step end phase as enabled or disabled.
[Step end]
The following parameters are provided to specify the action at the end of the
step.
•
Continue sequence (CONT)
•
Hold (HOLD)
•
Idle (STOP)
[Jump step]
The following parameters are provided to specify the destination step when a
jump occurs after ending the current step.
•
Jump to an arbitrary number step (1 to 255)
•
Jump to the next number step (0)
[Jump times]
The following parameters set a loop for jumping to the step specified by [jump
step] the specified number of times.
The following parameters are provided to specify the jump times.
•
Specified number (1 to 999)
•
Infinite times (0)
[Branch step]
The following parameters are provided to specify the destination step for
branch control.
•
Change to arbitrary step number (1 to 255)
•
Continue step processing without changing (0)
When start is commanded during normal output while in idle mode, step 1 is executed, then the step jumps
according to the specified sequence.
If the [jump step] has not been specified (= 0), the step jumps according to the sequence of step numbers,
but when the [jump step] has been specified (= 1 to 255), the step jumps to the step specified by that
parameter.
A step ends when the time specified by the [step time] has elapsed. If the [step end phase] has been
specified as enabled, the step ends when the [step end phase] value becomes (0
°
) after the [step time] has
elapsed.
If both [step end] and [jump step] have been specified, the [step end] specification takes priority.