NF EC1000SA, Инструкция по эксплуатации

Страница: 234 / 283

6.6 Error Message List
EC1000SA 6-56
6.6 Error Message List
Error messages are listed in
Table6-16
below
.
Table6-16. Error Message List
No. Message Cause
0 “No error” No error.
−
100 “Command error”
Command was recognized as invalid due to any cause.
(General command error)
−
102 “Syntax error”
Command was recognized as invalid due to reception of
undefined command or parameter.
−
200 “Execution error”
Error occurred when executing the command due to any cause.
(General execution error)
−
222 “Data out of range”
Error occurred when executing the command due to out of range
parameter.
−
350 “Too Many Errors” New errors cannot be retained due to error queue overflow.
1 “Invalid with output on”
Error occurred when executing the command because the output
relay was on.
2 “Invalid with output off”
Error occurred when executing the command because the output
relay was off.
3 “Invalid in this mode”
Error occurred when executing the command due to inappropriate
output mode.
4 “Under Busy State” Error occurred during execution of command due to busy device.
5 “Out of Limiter”
Error occurred during execution of command because limiter
value was exceeded.
6 “Invalid in this frequency”
Error occurred when executing the command due to inappropriate
oscillation frequency setting.
7
“Out of Input Signal
frequency” Error occurred when executing the command due to out of the
external synchronization frequency range.
8 “Under Warning State”
Error occurred when executing the command because device was
operating in protected mode.