NF EC1000SA, Инструкция по эксплуатации

Страница: 28 / 283

2.3 Grounding and Power Supply Connection
EC1000SA 2-7
Connect the power in this order.
1.
Make sure that the power source voltage to be used is within the specified range.
2.
Set the power switch to off.
3.
Insert the power cord into the inlet on the rear panel.
Inlet
Figure 2-2. Power Source Inlet
4. Insert the power cord plug into a power supply outlet that includes a protective ground contact.
Before connecting the accompanying power cord 2 to a touchable terminal, be sure to interrupt a
power supply. An electric shock may occur.
The accompanying power cord 1 (Japan version) complies with Japan Electrical Appliance and
Material Safety Law and is for use in Japan only. The rated voltage is 125 V AC and the withstand
voltage is 1250 V AC. This power cord cannot be used when the voltage exceeds 125 V AC or in
locations outside of Japan.
The accompanying power cord 2 is intended for use in Japan, North America, and Europe. The rated
voltage is 250 V AC and the withstand voltage is 2000 V AC. Attach a plug or crimp contact that
suits the use environment. When using this cord in Japan, be sure to use a plug that complies with
Japan Electrical Appliance and Material Safety Law.
The accompanying power cords are for use with this product only. Do not use them with other
products or application systems. Use only the attached power code for connection to AC power line.
The product itself has a withstand voltage of 1500 V AC.
！ ！ ！ ！
CAUTION
！
！ ！
！ CAUTION
！ ！ ！ ！
CAUTION
！
！ ！
！
WARNING