•
Firmware update: During the Setup Wizard process, you can update the firmware
(if new firmware is available).
At the end of the Setup Wizard process, the AP restarts. Do not close the browser
page. Your WiFi-enabled computer or mobile device might be disconnected.
12. If your WiFi connection was terminated, reconnect to the AP.
If you set a new WiFi network name (SSID) and WiFi password during the Setup
Wizard process, use your new SSID and WiFi password to reconnect.
13. Log in again to the local browser UI by entering your new local device password.
This is the password that you specified during the Setup Wizard process.
The BASIC Home page displays.
The Home page displays various panes that let you see the status of your AP at a
glance. You can now configure and monitor the AP.
14. If you are using the AP in a country other than the U.S. or Canada (where the region
is set and you cannot change it), set the country or region where you are using the
AP by doing the following:
a. Select Advanced > Advanced Setup > Wireless Settings.
b. From the Region menu, select the country or region where you are using the AP.
Note: Make sure that the country is set to the location where the device is
operating. You are responsible for complying with the local, regional, and national
regulations for channels, power levels, and frequency ranges.
c. Click the Apply button.
Your settings are saved and the AP is configured for the new country or region.
If you are connected over WiFi, your connection might be terminated.
d. If you want to continue to configure the AP, reconnect to the AP (if you were
connected over WiFi and your connection was terminated) and log back in to
the local browser UI by entering your local device password.
User Manual
31
Installation and Initial Log-in
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
