Base Radio Alarms
Chapter 13: MTS Troubleshooting
Table 13-7
Generic Base Radio Alarms (Continued)
Alarm ID
Description
Recovery
Action
Clear Action
Notes
ALM_BRC_CP2B_REF_ALM
CP2B reference
is not present
- the alarm
originates from
the STIC FPGA
(which is read
by DSP) and it
is reported as a
fault indication
message from
DSP
Hardware
automatically
selects another
reference which
is present.
The alarm will
be cleared after
de-keying BRC.
The alarm may be
reported because of
the external reference
failure or BRC
hardware failure.
ALM_DEKEY_FROM_MMI
BRC is
de-keyed by
using ’dekey’
MMI command
BRC is de-keyed
by the software.
The alarm will
be cleared (and
BRC will be
re-keyed again)
after using ’key’
MMI command.
ALM_GPS_FAILURE
GPS failure
detected - 1PPS
signal is lost.
No recovery
action taken by
the software.
After de-keying
BRC and
regaining the
1PPS signal the
alarm is cleared.
The alarm may be
reported because of
the 1PPS signal from
SC failure or link to
SC failure or BRC
hardware failure.
ALM_RESET_PENDING_ALARM
CMP Reset
request received
from Site
Controller but
delay time for
the reset is set.
After the delay
time elapses the
BRC is reset.
The alarm will be
cleared only after
resetting BRC.
ALM_HW_INIT_FAILED
Hardware
initialization
failure.
No recovery
action taken by
the software.
The alarm will be
cleared only after
resetting BRC.
The alarm may be
reported because
of BRC hardware
con
fi
guration error
or BRC hardware
failure.
ALM_RX1_PATH
RSSI for
Receiver path
1 is much
lower than
maximal RSSI
measured for
the remaining
con
fi
gured
paths.
No recovery
action taken by
the software.
When the clear
condition is met
then the alarm is
cleared.
Each time when RSSI
for path 1 is less than
(max_RSSI - mts_re-
ceive_path_thresh-
old) then RSSI failure
counter for path 1
is incremented by 1.
Otherwise the counter
is decremented by 2.
After checking the
alarm condition the
counter is set to 0 if it
has a negative value.
The ’rssicnt’ com-
13-36
6802800U74-N September 2009
Содержание DIMETRA MTS 2
