Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 199 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual CAN Bus Cabling
CAN Bus Cabling
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
The CAN Bus is integrated in the Site Controller. There is one CAN Bus in the cabinets. The CAN
Bus can be connected to the Site Controllers, PSUs, DPMs, and ATCCs.
The pinout has been designed so that an accidental mis-connection by one or into one of the
other RJ45 connectors (Ethernet, Service port, or E1) does not damage any circuitry.
The CAN Bus is a 120 Ω twisted line with termination at the ends.
MTS 2 CAN Bus Cabling
The Site Controller contains the internal termination in one end of the CAN Bus, and the last
Duplexer in the CAN Bus has a terminator in one connector.
Table 5-26 and Table 5-27 identify
and Figure 5-25 and Figure 5-26 show the CAN Bus cabling in MTS 2.
CAN Bus cabling depends on
fi
lter con
fi
guration.
Table 5-26 CAN Bus Cabling for MTS 2 with TX/RX on 1 ant. RX on 2 ant.
Index
Cable Part
Number
From Unit / Connection
Name
To Unit / Connection
Name
Notes
MTS 2 (TX/RX on 1 ant. RX on 2 ant.)
1 3066575B01 Site Controller/ CAN Power Supply Unit/ CAN1 Red cable
2 3066544B10 Power Supply Unit/ CAN2 Duplexer/ CAN1 Red cable
3 0966513A01 Duplexer/ CAN2 CAN Bus termination
6802800U74-N September 2009
5-51