Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 471 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual How to Install
Procedure 15-12 How to Extract the Module Cage from MTS 2 (Continued)
5
Remove bottom plate by removing the 20 pcs M3 TEXTRON screws using M1.5 Hex.
Figure 15-17 M3 Screw position
6
Remove the Ribbon cable from the Module cage.
7
Mount the two brackets to the Module cage using 10 pcs. M4 screws.
8
Bend in the area at the back of the Module Cages for Ribbon cables to be routed through later.
Procedure 15-13 How to Assemble the Module Cage in the MTS 4 Cabinet
1
Remove the Module Cage Beauty Plate (if any).
2
Mount all cables going from the lower Module Cage in your speci
fi
c con
fi
guration and
fi
x them
temporarily in the rack before mounting the air separator shelf and module cage.
This would typically be:
•
Ethernet cables from Base Radio(s) in lower Module Cage to SC
in upper Module Cage (SC2).
•
Ethernet cables from Base Radio(s) in upper Module Cage to SC
in lower Module Cage (SC1).
•
CAN Bus cables to and from Filters.
3
Assemble the Air Separator shelf above the existing Module Cage using four M6 screws.
4
Assemble the Module Cage extracted from MTS 2 in Procedure 15-12 .
For more information regarding assembling of a module cage in the MTS 4 Cabinet,
see Adding Additional Module Cage to MTS 4.
6802800U74-N September 2009
15-41