Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 294 / 517

MTS - Restoration Procedures Chapter 8: Site Controller
MTS - Restoration Procedures
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
You must be familiar with Man-Machine Interface (MMI) commands and their
usage prior to performing procedures in this chapter. Improperly applying
MMI commands can result in equipment damage.
You must disable Black Ice or any other Firewall application before attempting to transfer
fi
les.you must disable Black Ice or other Firewall application before attempting to transfer
fi
les
The MTS Site Controller has the following modes of operation:
•
BOOT1 - to access this mode interrupt the booting process by pressing
Escape
key or
Control-C
combination when appropriate message is shown. A
password may be required to enter this mode.
•
Test Application - to access this mode enter the
testapp
command when in
BOOT1 mode. To go back to normal Site Controller Application enter
reset
-oplatform
command to reboot and resume normal operation.
•
Site Controller Application - if the boot process is not interrupted, this
is the default mode of operation.
Table 8-7 MTS - Restoration Impact
Action Service Affected Service Downtime
Replacing a Site
Controller Site will be off air, radios have to
fi
nd
service on other site.
If the site is a dual Site
Controller site, a switchover
of Site Controller would cause
outage of approximately 2
minutes. A switch back to the
newly replaced Site Controller
for testing could also introduce
outage of approximately 2
minutes.
Approximately one hour. Does
not include Ki’ing of site because
this depends on if the KVL has
to be driven back to the Switch
site where the AuC is located.
8-18
6802800U74-N September 2009