Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 229 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Con
fi
guring the pm_con
fi
g
Configuring the pm_config
Procedure 6-4 explains how to con
fi
gure pm_con
fi
g on the Site Controller.
For more information about how to use the pm_con
fi
g command, refer to
MTS Man
Machine Interface Commands Manual
.
Pm_con
fi
guration de
fi
nes the relationship between RFDS components and Base Radios. If one
cavity in an ATCC measures a high Voltage Standing Wave Radio (VSWR), it results in the decay
of the corresponding Base Radio. A broken antenna or failure on a feeder cable indicates a
bad VSWR on the DPM. It also results in the decay of Base Radios using this DPM.
Procedure 6-4 How to Configure pm_config
1
To set up pm_con
fi
g for MTS-4 with ATCC and one TX antenna, use the
following commands:
•
pm_config br 1 dpm 1
•
pm_config br 1 atcc 1 cav 1
•
pm_config br 2 dpm 1
•
pm_config br 2 atcc 1 cav 2
•
pm_config br 3 dpm 1
•
pm_config br 3 atcc 2 cav 1
•
pm_config br 4 dpm 1
•
pm_config br 4 atcc 2 cav 2
To get help, use the following command:
SC: pm_config -
If Expansion cabinet is used,
pm_config
needs to be setup accordingly.
By default, the following commands could be used:
•
pm_config br 5 dpm 3
•
pm_config br 5 atcc 3 cav 1
•
pm_config br 6 dpm 3
•
pm_config br 6 atcc 3 cav 2
•
pm_config br 7 dpm 4
•
pm_config br 7 atcc 4 cav 1
•
pm_config br 8 dpm 4
•
pm_config br 8 atcc 4 cav 2
2
To con
fi
gure the DPM and ATCC mapping to BR, use the following command:
pm_config [-?]
3
To con
fi
gure the ATCC (cavity) to BR mapping, use the following command:
br <br> atcc <atcc> cav <cavity>
6802800U74-N September 2009
6-21